Features of the Onguard 800 System Rack Enclosure

  • EIA industry standard rack expandable up to 19"
  • High current 5 amp AC or DC relay connections
  • Screw latch locks modules in place
  • Gold plated card edge connectors
  • All modules bussed to each other
  • Only 3.5" high
  • Steel housing reduces RF penetration
  • User specified polarized keying of module location
  • Up to four isolated zones
Allestec Rack Enclosure for the Onguard 800 Series Gas and Fire Control Panel

Onguard 800 System Rack Enclosure

The Allestec model 800 expandable panel accommodates all modules of the 800 series gas and fire suppression family. Constructed of durable .1" zinc chromate plated steel, the heavy-duty housing is designed for rigorous use in industrial and high hazard environments. The standard EIA 19" rack can be custom ordered to any length, occupying minimum space while maximizing configurations. Matching blank modules can be ordered to occupy any open slots. The maximum height of the rack is only 3.5" and is supplied with a locking clear Plexiglas door. An alternative architect bezel kit (shown) is also available.

System Mother Board

The back of the panel assembly incorporates a full-length motherboard allowing the transfer of signal communication between the modules. Durable Phoenix terminal strips are connected to the customer accessible rear panel allowing easy wire insertion by the 45 degree angle of the connectors. The motherboard terminal block connections are designated by the copper etch on the board itself and by the label located directly on the terminal strips.

Power and ground terminals are located below the main terminal strip and accommodate dual power supply connections. This power plane is bussed across the motherboard, supplying power to all modules and their respective appliances connected to the terminals.

Approvals

     

Specifications of the Onguard 800 System Rack Enclosure

Accommodations:

Maximum 16 modules

Mounting positions:

Any angle

Electrical connections:

No active device other than transient suppression
Terminal connections rated at 5 amps, 30 VDC
Contact Allestec for AC operation

Weight at 19":

7.5 lbs.

Material housing:

.1" thick Zinc chromate plated steel side panels, top and bottom are .059" thick
Housing assists in the attenuation of induced RF radiation

Back plane mother board:

3/32" thick FR4 two-ounce fiberglass, UL listed
Double sided plated printed circuit board
Solder mask on both sides of the board

Module location:

Any order except Fault Module required on right side of last module
Polarizing keys supplied for final location of modules

Field wire connections:

Ten-position terminal strip for each module accepts up to a 14 AWG single or stranded connector

Power connection:

Screw type terminal blocks for 24 VDC connection of dual power supplies
Terminal strip accepts up to 14 AWG single or stranded connector


Part Number Description

800-1690-XX

Rack assembly with low profile bezel - X represents number of slots required

800-1192-XX

Rack assembly with front locking door - X represents number of slots required

Onguard 800 Series Gas and Fire Control Panel Components

Onguard 800 Series Gas and Fire Control Panel - A Modular Special Hazard Safety System

Copyright © 2024 Allestec Corporation. All rights reserved.